Description
High adhesion for ceramic tiles and porcelain tiles
Ensures a firm and durable bond on conventional substrates, walls, and floors.
Comfortable and controlled work
Easy application with long working time and scope for rectifying parts.
Ready to use
Just add water, no need to wet the pieces to speed up the work.
T5 is ideal for projects where a reliable adhesive for porcelain and ceramic tiles is required, with simple application and sufficient margin to adjust pieces during installation.
Its high adhesion and extended working time make it a practical solution for both indoor and outdoor installations, ensuring a firm bond to walls and floors.
High adhesion for porcelain tiles and ceramics.
Indoor and outdoor use.
Easy application and good workability.
Suitable for walls and floors.
Extended working hours.
No need to moisten the pieces before placing them.
Allows you to rectify parts with ease.
Ready to use: just add water.
Technical data
Mixing ratio
Performance
Tile adjustment time
Pot life (hardening):
Joint installation:
Application temperature:
Presentation
Storage
Service life
Preparation of the mixture and application instructions:
Pour 6.75 liters of water into a suitable container for each 50 lbs bag of T5 Porcellanato T-CON cementitious adhesive.
In a well-ventilated area and wearing a dust mask, add the product while mixing slowly with a drill mixer. After adding all the powder, mix at high speed until you get a uniform, lump-free mixture (about 2 to 3 minutes). Let the mixture rest for 5 minutes, then remix for about 30 seconds.
Apply the cementitious adhesive to the substrate where the tile will be installed, over an area no larger than 2 m². Then use the selected notched trowel to control the thickness of the application.
Place the pieces onto the freshly applied adhesive, pressing until the piece is fully wetted against the substrate to ensure proper installation.
Randomly check the adhesive contact with the installed piece by lifting one that was previously placed. If you notice areas without adhesive on the surface or dried-out mix, reapply the cementitious adhesive and reinstall the piece.
Install properly, taking into account the layout of movement and expansion joints to prevent substrate failures caused by its expansion and contraction.
Frequently asked questions
Can it be applied over damp surfaces?
Yes, WP91 Ultra Flex can be applied over damp surfaces, as long as the substrate is sound, clean, and free of materials that could affect adhesion.
What types of surfaces is it suitable for?
It is suitable for concrete, plaster, and other stable, structurally sound substrates. Any irregularities must be corrected beforehand with the appropriate mortars.
How many coats, or what thickness do I need to apply?
It is recommended to ensure a minimum thickness of 2 mm at any point, which implies an approximate consumption of 2.4 kg/m².
When can I open the surface for use?
The surface can be opened for use 48 to 72 hours after application, depending on environmental conditions.
