F11

All substrates must be dry, stable, and structurally sound. If necessary, mechanically clean the substrate by polishing or other methods until a solid and firm substrate is obtained. Mechanically clean any substance that could interfere with the adhesion of the mortar (e.g., grease, oil, wax, dust, plaster, paint, etc.).

Test the porosity using a water droplet test. Sprinkle water on the surface; if the water forms droplets without being absorbed within 2 minutes, the surface is not porous and is probably contaminated. Such contaminants must be removed and the surface must be worn down using a mechanical method such as scarification or mechanical grinding.

Print the surface with the T-CON line adhesion promoter appropriate for the surface to be coated. The tempera

Both on porous substrates where aesthetics are important (commercial premises, hotels, homes, etc.) and on all non-porous substrates, apply Primer EPX T-CON according to the corresponding technical data sheet.

In areas where aesthetics are not as important and the substrate is porous (warehouses, mechanical workshops, etc.), apply Primer P10 T-CON according to the corresponding technical data sheet. If used for the Self-Leveling Polished Cement System, it is recommended to always use Primer EPX T-CON.

If you have any questions, please contact the T-CON technical department or your assigned representative.

F11 T-CON Self-Leveling Mortar should not be installed over moving joints or cracks. These must be respected, down to the
base and floor (existing expansion, insulation, and construction).

It should be noted that, as it is a surface finish, it cannot prevent structural movements, which may cause reflective cracks. Among the areas most prone to crack transmission are areas with vibration in a concrete slab due to truck or heavy transport traffic, apartment buildings that move in the wind, existing cracks in the floor, control joints or closed joints, expansion joints, protrusions from different substrates, and small cracks that form in the corners of metal applications such as electrical boxes.

Although priming with Primer EPX T-CON is the best way to minimize the possibility of reflective cracks, these can be transmitted to the surface if structural movement is significant.

It is recommended to mix 2 bags of F11 T-CON self-leveling mortar in each preparation.
First add the water and then the powder. It is recommended to do this in a well-ventilated area and to wear a dust mask. Use a mixer or heavy-duty drill (½” (12 mm, min. 650 rpm)) to mix each 25 50 pounds bag of F11 T-CON Self-Leveling Mortar with 4.75-5 liters of water (9.5-10 liters for 2 bags of 50 pounds).

Mezcle durante 2 a 3 minutos hasta obtener una preparación sin grumos. Si al mezclar aparece una espuma amarillenta o se asienta el agregado de arena, esto indica que hay exceso de agua. Una vez vertido en el piso, Mortero autonivelante T-CON F11 permite un tiempo de trabajo de 20 minutos a 23° C.

Pour the mixture onto the floor and spread it with the leveling tool. Immediately afterwards, smooth the material with the recommended metal trowel or spiked roller. Wear spiked shoes or cleats to avoid leaving permanent marks in the mortar liquid.