Description
S1 flexibility with high adhesion
It accommodates small substrate movements and ensures a long-lasting bond in demanding installations.
Comfortable and controlled work
Its reduced vertical slip and optimized thixotropy allow for more precise tile placement.
Versatile for interior, exterior, and wet areas.
Suitable for pools, radiant floor heating, and installation over existing surfaces, with excellent performance.
T11 Superflex S1 is a cementitious adhesive mortar with excellent workability, high flexibility (S1 transverse deformation), reduced vertical slip, extended open time, and high adhesion.
It is designed for installing ceramic tile, porcelain tile, stoneware, and natural stone, both indoors and outdoors, including over existing surfaces, radiant floor heating, and in pools.
High adhesion and secure bond.
Reduced vertical slip (better control).
S1 flexibility to absorb movement.
Extended open time for a more relaxed working pace.
Suitable for indoor and outdoor use.
Allows you to adjust tiles easily.
Ideal for large-format tile.
Does not require dampening the tiles.
Suitable for pools and wet areas.
Creamy consistency and easy application.
Technical data
Mixing ratio
Performance
Tile adjustment time
Pot life (hardening):
Joint installation:
Application temperature:
Presentation
Storage
Service life
Preparation of the mixture and application instructions:
Vierta en un recipiente adecuado 6,25 litros de agua por cada bolsa de 25 kg de Adhesivo cementicio T11 Superflex S1 T-CON. In a well-ventilated area and wearing a dust mask, add the product while mixing slowly with a drill mixer.
After adding all the powder, mix at high speed until you get a uniform, lump-free mixture (about 2 to 3 minutes). Let the mixture rest for 5 minutes, then remix for about 30 seconds.
Apply the cementitious adhesive to the substrate where the tile will be installed, over an area no larger than 2 m². Then use the selected notched trowel to control the thickness of the application.
Place the pieces onto the freshly applied adhesive, pressing until the piece is fully wetted against the substrate to ensure proper installation.
Randomly check the adhesive contact with the installed piece by lifting one that was previously placed. If you notice areas without adhesive on the surface or dried-out mix, reapply the cementitious adhesive and reinstall the piece.
Install properly, taking into account the layout of movement and expansion joints to prevent substrate failures caused by its expansion and contraction.
If installing over existing flooring, make sure to remove any poorly bonded pieces and ensure the old surface has no dirt or residue. If necessary, mechanically prepare the surface to be covered until it has increased roughness to ensure a long-lasting installation.
Frequently asked questions
Is T11 suitable for large-format tile?
Yes, it can be used for large-format tile thanks to its flexibility and high adhesion.
Can it be used in pools?
Yes, it is suitable for pools and water-contact environments due to its high adhesion under immersion.
Is it suitable for installing over an existing floor?
Yes, it is suitable for installation over existing flooring as long as it is sound and properly prepared.
Do the tiles need to be dampened before installing them?
No, the product does not require dampening the tiles.
How long does the prepared mix last?
The mix has an approximate pot life of 120 minutes.
