Description
High adhesion and reliability
Designed to achieve a strong, long-lasting bond, even in humid or exposed environments.
Comfortable and controlled work
Creamy consistency, extended open time, and low slip tendency for a more comfortable installation.
Versatile for interior, exterior, and demanding areas
Works for interior and exterior applications, in pools, and over existing flooring, and it is also suitable for radiant floor heating.
T6 is ideal for installations where secure adhesion, good workability, and an adhesive that’s comfortable to work with are needed, even on vertical surfaces or in demanding environments.
Its extended open time and creamy consistency make for a neat installation, with enough time to adjust pieces, both in new construction and in applications over existing coverings.
High adhesion.
Suitable for interior and exterior use.
Easy application.
Ideal for wet areas and pools.
Low vertical slip.
Compatible with multiple types of coverings.
Extended open time.
Suitable for underfloor heating.
Allows tile adjustment.
Just add water.
Technical data
Mixing ratio
Performance
Tile adjustment time
Pot life (hardening):
Joint installation:
Application temperature:
Presentation
Storage
Service life
Preparation of the mixture and application instructions:
Pour 6.5 liters of water into a suitable container for each 50 lbs bag of T6 Flexible T-CON cementitious adhesive. In a well-ventilated area and wearing a dust mask, add the product while mixing slowly with a drill mixer.
After adding all the powder, mix at high speed until you get a uniform, lump-free mixture (about 2 to 3 minutes). Let the mixture rest for 5 minutes, then remix for about 30 seconds.
Apply the cementitious adhesive to the substrate where the tile will be installed, over an area no larger than 2 m². Then use the selected notched trowel to control the thickness of the application.
Place the pieces onto the freshly applied adhesive, pressing until the piece is fully wetted against the substrate to ensure proper installation.
Randomly check the adhesive contact with the installed piece by lifting one that was previously placed. If you notice areas without adhesive on the surface or dried-out mix, reapply the cementitious adhesive and reinstall the piece.
Install properly, taking into account the layout of movement and expansion joints to prevent substrate failures caused by its expansion and contraction.
If installing over existing flooring, make sure to remove any poorly bonded pieces and ensure the old surface has no dirt or residue. If necessary, mechanically prepare the surface to be covered until it has increased roughness to ensure a long-lasting installation.
Frequently asked questions
What types of coverings can I install with T6?
It is suitable for ceramic tile, porcelain tile, stoneware, and natural stone.
Can it be used outdoors?
Yes, it is suitable for indoor and outdoor use.
Is it suitable for pools or wet areas?
Yes, it is suitable for pools thanks to its high adhesion under immersion.
Do the tiles need to be dampened before installing them?
No, the product does not require dampening the tiles.
How long does the prepared mix last?
The mix has an approximate pot life of 120 minutes.
How much time do I have to adjust the tile once it’s set?
Approximately 45 minutes of adjustment time.
