R6 Concrete repair mortar

Description

Fine repair without slippage

Allows you to work on vertical or sloped surfaces without the material shifting, achieving precise and controlled repairs in thin layers.

Excellent finish and workability

Its formulation offers superior workability and a very fine finish, ideal for visible restorations and neat finishes.

Durability and resistance for indoor and outdoor use

It has low shrinkage, good mechanical strength, and excellent durability against moisture, freezing, and thawing.

R6 is a non-structural repair mortar, formulated with hydraulic cements and reinforced with fibers, designed for the restoration and surface finishing of concrete and other substrates.

It allows application in thicknesses of 1 to 6 mm per coat, offers excellent workability, does not sag on vertical surfaces, and provides a smooth finish suitable for painting or protecting with a clear sealer. Suitable for interior or exterior use.

Non-structural repair.

Low shrinkage.

Thin thicknesses from 1 to 6 mm.

Reinforced with fibers.

Does not slide vertically.

Indoor and outdoor use.

Excellent workability.

Suitable for painting or lacquering.

Technical data

Mixing ratio

4.8 to 5.2 L of water per 50 pound bag

Performance

1.5 kg/m² per millimeter of thickness

Initial setting

90 minutes

Final setting

3 hours

Application thickness

From 1 to 6 mm

Suitable for pedestrian traffic

24 hours

Suitable for normal traffic

7 days

Pot life (mixture hardening):

60 minutes

Presentation

50 lbs bag (49 units per pallet)

Storage

Store in a cool, dry place above 5°C. Do not leave packaging exposed to sunlight. Keep away from heat sources.

Service life

9 months unopened from the date of manufacture

Surface preparation:

All substrates must be stable and structurally sound. If necessary, mechanically clean the substrate by polishing or other methods until a solid and firm substrate is obtained.

Mechanically clean any substance that could interfere with the adhesion of the mortar (e.g., grease, oil, wax, dust, plaster, paint, etc.).

Test the porosity using a water droplet test. Sprinkle water on the surface; if the water forms droplets without being absorbed within 2 minutes, the surface is not porous and is probably contaminated. Such contaminants must be removed and the surface must be worn down using a mechanical method such as scarification or roughing.

Moisten the surface or prime it with the appropriate T-CON adhesion promoter for the surface to be coated. En caso de duda consultar departamento técnico T-CON. La temperatura al momento de la instalación debe ser de al menos 5°C.

Preparation of the mixture and application instructions:

First add the water and then the powder while beginning to mix. It is recommended to mix in a well-ventilated area and wear a dust mask. Use a mixer, heavy-duty ½” (12 mm, min. 650 rpm) drill, or trowel, maintaining a ratio of 4.8 to 5.2 L of water (19 to 21%) per 50 pound bag of T-CON® R6 Repair Mortar. Add approximately 80% of the water before incorporating the product and the rest afterwards. Once prepared, it allows a working time of 60 minutes at 23°C.

Spoon the mixture onto the surface and spread it out. Then compact the mixture with a spoon and finally smooth it with a trowel. Warning: Protect the surface from splashes during the first few hours after installation. Curing: Keep the surface moist for 24 hours to prevent cracks from appearing.